Christie Mirage HD User Manual page 112

Section 4: Maintenance
4-8
6. INSERT THE NEW LAMP MODULE
Align the new lamp with the top and bottom guides on the left side of the lamp
compartment (see Figure 4.5). Slide the lamp all the way in – a slightly harder
push may be required right at the end to ensure it's fully seated into the terminal
block.
NOTE: The lamp module must make full contact with the terminal block. The
projector will not power up again if the lamp is not fully connected to the terminal
block.
Improper installation could cause a serious
7. LOCK IN THE NEW LAMP MODULE
Pull out and turn the lamp lock lever (turned up in Step 4) ¼ turn clockwise to
"lock" the lamp in place.
NOTE: If you can't turn the lamp lock into position, it is likely the lamp is not
fully inserted. In this case, partially remove the lamp and try pushing it back in
again. Then, try switching the lock lever to the "lock" position.
Figure 4.4. Remove Lamp Module
Figure 4.5. Insert New Lamp Module
WARNING
meltdown inside the projector.
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher