Adjusting The Image - Christie Mirage HD User Manual

3.5 Adjusting the
Image
Before You Begin
Size and Position Menu
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher
•
PREVIOUS CHANNEL:
the previous channel in the Channel Setup list.
•
Select this option to see or change Channel Edit settings for the
NEXT CHANNEL:
next channel in the Channel Setup list.
The most commonly used options for image adjustments are accessed through two
menus: Size and Position (
appear in the Main menu. From either of these two menus, you can change settings
affecting the image from the current channel by working with the appropriate slide
bars, checkboxes and pull-down lists.
presentation, if from the Main menu) and accept any changes you may have entered.
Settings are saved with the current channel.
From your presentation, you can access any of the individual options in these menus
by pressing followed by the appropriate two-digit number representing their
Menu
location in the menu system. For example, press
"Gamma" option in the Image Settings menu.
Note that for certain options, you may prefer to use a "direct key" from presentation
level to go directly to a particular option without traveling through the menu system
(available for certain display parameters only). For example, press
"contrast" slide bar immediately. Press
NOTES: 1) To hide these "direct" slide bars, disable the "Display Slide bars"
checkbox in the Menu Preferences menu. 2) To hide the entire menu system from
view, turn off the on-screen display by pressing
Use Auto Setup (
Auto
For a good and efficient first step in perfecting the image, press
automated process in which the projector quickly optimizes critical display parameters
such as size, position, pixel tracking, etc., based on the type of incoming source data
detected. An Auto Setup can save considerable setup time, and you can still modify
the adjustments as desired using menu options described below.
In the Size and Position menu, you can
increase or decrease the size of your image,
change its proportion (aspect ratio), move
the image to a specific area of the screen,
and refine other related parameters. Use
Size and Position controls to match the
image precisely to the screen used at the
site.
Refer to "Using Slide bars and Other Controls" (earlier in this section) if you need
help using any of the options and controls. Changes made in the Size and Position
menu are applied immediately and are saved when you exit the menu (press
).
Menu
.
Select this option to see or change Channel Edit settings for
1
) and Image Settings (
Menu
will return to the previous menu (or to the
Exit
to return to your presentation.
Exit
)
Section 3: Operation
2
), both of which
Menu
2 3 to quickly access the
Menu
Contrast
.
OSD
. This initiates an
Auto
to access the
or
Exit
3-19