Christie Mirage HD User Manual page 61

Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher
Mirage S+ Series — Simulation 3D —
SETTINGS
Use the options in the Simulation 3D
menu to make the timing adjustments
necessary for realistic simulation and
3D images.
NOTE: For complete 3D application
notes, refer to the separate Using 3D
in Mirage manual provided with the
Mirage projector.
FRAME DELAY MONITOR —
results, the value should remain fairly
constant, indicating that timing of input and output frames is locked; the Frame Delay
Monitor value should stay within 5-10 lines or so of the Frame Delay setting. If a
frame is lost or "dropped", this value will cycle to maximum and jump to minimum
and then repeat, indicating that the frame input is no longer equal to the output. If the
signal is not locked, the values will change erratically; you can adjust the Frame delay
to attempt a correction.
NOTE: See separate Using 3D in Mirage manual provided for more information.
Set the number of lines delayed between the input signal and its
FRAME DELAY —
appearance on screen, keeping in mind that projector processing always adds one
frame of delay to the frame delay setting. For applications such as simulation, where
the feeling of "real time" image response is a priority, a minimum setting is usually
preferable. For projectors capable of 3D (stereographic) applications where alternating
left-right frames must be synchronized with the corresponding L/R shutters in 3D
glasses, a total frame delay setting of two (or multiple of two) may be more useful. If
set too high or low, frame locking will not be possible—most sources require
approximately 50 lines of delay to ensure frame locking.
NOTE: See separate Using 3D in Mirage manual provided for more information.
Adjust Dark Interval to artificially increase the amount of dark
DARK INTERVAL —
time between displayed frames for stereographic 3D images. Higher settings provide
more time for shutters in 3D glasses to open/close, ensuring that each eye sees the full
display intended for it. Symptoms of cross talk and/or color artifacts can indicate need
for adjustment. The Dark Interval range of adjustment depends on the vertical
frequency of your source—the higher the frequency, the smaller the range.
NOTE: See separate Using 3D in Mirage manual provided for more information.
3D STEREO SYNC LOCKING —
stereographic 3D signal locks to the vertical sync output so that signals are
synchronized, and 2) whether or not the 3D frames must be inverted, i.e. swapped left-
with-right. The correct setting ensures that the projector's 3D display of left/right
frames is synchronized with the rest of the 3D system components so that the intended
eye sees the left/right image data. Select the option corresponding to your 3D source
connections and timing, and use only if the Mirage 3D Stereo Sync Cable is connected
between the projector's GPIO port and a server. Keep this adjustment OFF (default)
when you are not using the Mirage 3D Stereo Sync Cable.
.
SUBMENU OF ADVANCED IMAGE
Frame Delay Monitor
1.
2.
3. 3D Stero Sync Locking
4. 3D Stero Sync Select
5.
3D Stereo Sync Delay
6. Frame Lock Enable
7.
For best
This option defines 1) whether or not the incoming
Section 3: Operation
Simulation 3D
1047
Frame Delay 1000
128
Dark Interval
Output
Input A
1000
Locked
Reserved
Mirage S+ Models
3-33