Christie Mirage HD User Manual page 70

Section 3: Operation
3-42
Figure 3.8. Using the "Network Routing" Option
RS232 AND RS422 JOINED:
will be relayed to all RS232or RS422 ports. Any Ethernet communication, however,
will not.
RS232 AND ETHERNET JOINED:
relayed to the Ethernet port, and vice versa. Any RS422 communications will be
isolated.
All messages reach all ports, regardless of type.
ALL JOINED:
Ethernet Settings
(SUBMENU)
NOTE: Recommended for network administrators only.
Enable this checkbox if you want a DHCP server to automatically change the
DHCP:
projector's default IP address (0.0.0.0) to one that is valid and unique for use on the
current Ethernet network. On networks without a DHCP server, or to simply override
the automatic DHCP server function, delete the checkmark and enter the new "IP
Address" settings desired. Remember that only a 0.0.0.0 address will trigger the
DHCP addressing service, and only when the DHCP checkbox is enabled.
Enter a valid and unique IP address for use on the network to which the
IP ADDRESS:
projector is currently connected. This address will overwrite any previous IP address
such as the projector's factory-defined default (0.0.0.0), or one that has been assigned
by a DHCP server or other user. It takes approximately 10 seconds for the projector to
respond at its new address.
Messages originating from an RS232 or RS422 controller
Messages to and from the RS232 ports will also be
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher