Christie Mirage HD User Manual page 100

Section 3: Operation
User Errors
Input Signal Errors
System Warnings / Errors
3-72
Note that a two-digit error code appears in the status LED display window located
beside the built-in keypad at the rear of the projector. Normal operation is indicated by
the "0n"status code.
Invalid User Entry
A keypad entry not recognized by the projector triggers a short on-screen error
message identifying the problem. For example, if you specify a channel number that is
not available, the message "Invalid Channel will appear. Or if you try to enter the
wrong password, you'll see "Invalid Password". Press
message and try again.
NOTE: On-screen display of "Invalid User Entry" messages cannot be disabled, even
if Display Error Messages has been set to "Off".
An input signal error message occurs if you are in presentation level (i.e., there are no
menus present) and have selected an input on which the projector detects a problem.
While menus remain operational and any key press will temporarily remove any
displayed error message, you must resolve the signal problem in order to permanently
eliminate the message.
No Signal
The message "No signal" occurs when there is no source signal detected at the
selected input—both HSYNC and VSYNC are inactive and the screen background is
black. Connect or correct the signal, or try another input.
Bad Sync
The message "Bad Sync" occurs when HSYNC or VSYNC are active but the signal
cannot be displayed. Such a condition occurs when only one of the two sync signals is
present or when either sync signal is unstable or is the wrong frequency. Correct the
signal or select another input.
Other Signal Error Messages
In addition to the common "Bad Sync" and "No Signal" errors, you may encounter a
signal error message indicating that HSYNC and/or VSYNC are either too fast or too
slow. When such a message appears, check the frequencies shown in the Status menu.
If they are correct, the projector does not recognize the signal. On some PCs you may
be able to change the settings to generate a compatible signal. If the frequencies
shown in the Status menu are incorrect, check the cabling to see where the problem
might originate.
When the projector encounters a system malfunction, either a System Warning
message or a System Error message may appear. Both types of messages are
accompanied by a numerical error code on the status LED display. A system
malfunction can be cleared with
the need for service by a qualified service technician.
from presentation level, but may indicate
Exit Exit
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
or to clear the
Exit
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher