Christie Mirage HD User Manual page 102

Section 3: Operation
3-74
Table 3.5 Error Codes
Code Description
GENERAL
12 Software bug. Contact dealer/factory.
13 CRC error in flash ROM. Download new software.
14 Engineering-only programming is complete. Call Christie, replace TIPM.
15 Attempting to download code without being in boot mode
16 Invalid interrupt. Power off/on. If it persists, contact dealer/factory.
17 User forced system to stay in boot mode
18 Jumper for programming boot not installed
1E
External 3D Input Sync missing. Refer to section 5 Troubleshoot
1F External 3D Input Sync is wrong. Refer to section 5 Troubleshoot.
LAMP FAILURES
20 Lamp turned on unexpectedly (fault related to ballast)
21 Lamp airflow low, overheating imminent
23 Cannot read valid ballast ID
26 Lamp Interlock: lamp door open, lamp not installed
27 Can't turn lamp on
28 Lamp turned off unexpectedly
29 Lamp ballast overheated
POWER AND COOLING
46 Red DMD heatsink overheated
47 Green DMD heatsink overheated
48 Blue DMD heatsink overheated
49 Prism overheated
4C Projector shutdown due to critical error
C0 Lamp blower failure (lamp not turned on)
51 LVPS fan failed (Fan 1)
52 LVPS/ Red cooling fan failed (Fan 2)
53 DC lamp fan failed in 500W / 1kW models (Fan 3)
54 Red DMD heatsink fan failed on 1kW and 1.2kW models (Fan 4)
55 Green DMD heatsink fan failed on 1kW and 1.2kW models (Fan 5)
56 Blue DMD heatsink fan failed on 1kW and 1.2kW models (Fan 6)
57 TIPM fan failed (Fan 7)
58 TIPM fan failed (Fan 8)
TIPM (Image Processor)
60 Boot code CRC failed
61 Unable to program DigMux PLD
62 Unable to program Control PLD
63 Unable to program Bubks PLD
64 Unrecognized ROM type
65 Write to flash ROM failed
66 TIPM failure
67 Downloaded code will not fit
68 Scaler communication problem
BUILT-IN KEYPAD
70 Unable to access EEPROM on the built-in keypad
71 EEPROM memory re-initialization on the built-in keypad
.
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher