Paper Feeding Problems; Wrong Print Position; Multi-Feeding; Paper Rolled In The Fuser - Xerox Phaser 3300 Servce Manual

General Troubleshooting

Paper Feeding Problems

Wrong Print Position

Multi-Feeding

Paper rolled in the fuser

4-8
Printing begins when the paper is in the wrong position.
Check and Cause
A defective feed sensor actuator can
cause incorrect timing.
Multiple sheets of paper are fed at once.
Check and Cause
1. Solenoid malfunction (the solenoid
does not work properly).
2. Friction-pad is contaminated with
foreign matter. (oil.)
3. The face of paper is smudged.
Paper rolled in the fuser 100.5 mm
Check and Cause
1. Contamination of the pressure roller or
heat roller.
(Background, Hot off set).
2. Check the claw of the fuser whether it
is deformed.
Solution
Replace the defective actuator.
Solution
1. Replace the solenoid if necessary.
2. Clean the friction-pad with soft cloth
dampened with water.
3. Use the smooth paper.
Solution
1. After disassembling the fuser, clean
contamination between the heat roller
and the thermistor and remove the
contamination of the pressure roller.
2. If there is heavy background, repair it
by the background troubleshooting
method.
3. Clean the surface of the heat roller with
IPA or water.
4. Check the warp or separation of the
print claw and the holder plate claw, and
then manage it.
Phaser 3300MFP Service Manual