Ghost (2); Ghost (3); Ghost (4) - Xerox Phaser 3300 Servce Manual

Ghost (2)

Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer

Ghost (3)

Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer

Ghost (4)

Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Phaser 3300MFP Service Manual
Ghost image occurs at 75.5 mm intervals of the OPC drum on the output
when printing on card stock or transparencies using manual feeder.
Check and Cause
When printing on card stock thicker than
normal paper or transparencies, higher
transfer voltage is required.
White ghost image occurs in the black image printing at 35.2 mm intervals.
Check and Cause
The life of the print cartridge may be
expired.
The abnormal voltage and bad contact of
the terminal of the developing roller.
Ghost occurs at 88.9 mm intervals.
Check and Cause
The temperature of the fuser is too high.
Print-Quality Troubleshooting
Solution
Select 'Thick Mode' on paper type menu
from the software application. After use,
return to the original Mode.
Solution
Problem in the print cartridge. Replace
the print cartridge and re-run the job.
Check the approved voltage of the
supply roller and contact of the terminal
and adjust if necessary.
Solution
Caution: Handle the heat roller carefully
to avoid deforming the roller.
Allow the Fuser to cool at least 5
minutes.
1. Disassemble the fuser.
2. Remove the contaminated toner
particles on the roller.
3. Clean the foreign matter between
thermistor and heat roller.
5-15