Notations In The Disassembly Text - Xerox Phaser 3300 Servce Manual

Notations in the Disassembly Text

Phaser 3300MFP Service Manual
The notation "(item X)" points to a numbered callout in the illustration
corresponding to the disassembly procedure being performed.
The notation "PLX.X.X" indicates that this component is listed in the Parts
List.
Bold arrows in an illustration show direction of movement when removing
or replacing a component.
The notation "(tap, plastic, 10 mm)" or "(metal, 6 mm)" refer to the type of
screw being removed.
Note
Provides information specific to the replacement of parts or
assemblies.
Caution
Use care when installing self-tapping screws in plastic. To properly start the
screw in plastic, turn the screw counter-clockwise in the hole until you feel the
screw engage the threads, then tighten as usual. Failure to properly align or
over tighten the screw can result in damage to previously tapped threads.
Always use the correct type and size screw. Using the wrong screw can
damage tapped holes. Do not use excessive force to remove or install either a
screw or a printer part.
Service Parts Disassembly
8-5