JAM 1
Phaser 3300MFP Service Manual
Check and Cause
3. If continuous clusters occur, check
whether the assembly slot between shaft-
pickup and housing-pickup become open
or is broken away.
4. If the paper feeds into the printer and
Jam 0 occurs, check feed-sensor of the
Control Board.
Description
1. Paper is jammed in front of or inside the fuser.
2. Paper is stuck in the discharge roller and in the fuser just after passing
through the Actuator-Feed.
Exit Sensor
Pressure Roller
Check and Cause
1. If the paper is jammed in front of or
inside the fuser.
2. If the paper is stuck in the discharge
roller and the fuser just after passing
through the Actuator-Feed, Feed Actuator
may be defective.
Solution
3. Replace the Housing-Pickup and/or
Shaft-Pickup.
LSU
CR
OPC
Fuser
Transfer Roller
Feed Sensor
Empty Sensor
Solution
1. Replace the HVPS.
2. Reassemble the Actuator-Feed and
Spring-Actuator if the return is bad.
Error Messages and Codes
DR
Toner Cartridge
SR
PTL
MP Sensor
Feed Roller
s3300mfp-068
3-3