Eap Credentials; Thirdpartyconfig - Psion Teklogix 7527C-G2 User Manual

Appendix A: Summit Client Utility (SCU)

EAP Credentials

•• LEAP: Strong passwords are recommended.
•• EAP-FAST: SCU supports automatic, not manual, PAC provisioning.
EAP-TLS will work with a 802.11b/g radio module when Windows Zero Config (WZC)
rather than the SCU is used to configure the type. With WZC, the native Windows suppli-
cant instead of the SCU integrated supplicant is used.
A.3.2 EAP Credentials
Keep the following in mind when defining security settings:
•• If the credentials specified in the profile are incorrect and that profile is used, the
authentication fails without an error message; you will not be prompted to enter
correct credentials.
•• If the credentials are not specified in the profile, when the radio tries to associate using
that profile, you will be prompted to enter the credentials.
•• When prompted, you can enter valid credentials, enter invalid credentials, or cancel
the operation.
•• If you enter valid credentials and tap OK, the radio will associate and authenticate.
•• If you enter invalid credentials and tap OK, the radio will associate but will not authen-
ticate; you will be prompted again to enter credentials.
•• If you tap Cancel or clear the credentials fields and tap OK, the radio will not attempt to
associate with that profile until you perform one of the following actions (while the
profile is the Active Profile):
- Cause the WORKABOUT PRO
- Disable and enable the radio, or tap the Reconnect button on the Diags windows.
- Modify the profile, and tap on Commit.
Alternatively, you can choose another profile as the active profile and then switch back to
the profile for which EAP authentication was cancelled.
A.3.3

ThirdPartyConfig

If you choose to configure ThirdPartyConfig, the SCU will work with the operating sys-
tem’'s Windows Zero Config (WZC) to configure radio and security settings for the CF radio
installed in the unit.
Choosing this profile means that WZC must be used to define the following radio and secu-
rity options: SSID, Auth Type, EAP Type and Encryption. The SCU settings for
ThirdPartyConfig include: Client Name, Power Save, Tx Power, Bit Rate and Radio Mode.
A-6 WORKABOUT PRO
3
with Windows Mobile 6.1 User Manual
3
to go through a power cycle or suspend/resume.