Decoded (Internal) 2D Scanning Options; Data Options —- Decoded (Internal) Scanner - Psion Teklogix 7527C-G2 User Manual

Bi-Direction Redundancy
Note: This parameter is only valid if a “"Linear Security Level”" is enabled.
When this parameter is enabled, a bar code must be successfully scanned in both directions
(forward and reverse) before being decoded.
Scan Angle
This option allows you to choose from two scan angles: Normal Angle or Alternate Angle.
Choosing Normal Angle allows the normal operation for scanning long range and short
range. Choosing Alternate Angle widens the beam to allow scanning of long bar codes at
short range but at the cost of long range scanning.
D.2.3

Decoded (Internal) 2D Scanning Options

Scanning Mode
When you double-tap on this parameter, a dialog box is displayed in which you can choose
one of the following scanning modes: Smart Raster, Always Raster, Programmable Raster,
Slab Pattern, Cyclone Pattern or Semi-Omni Pattern.
Raster Height And Raster Expand Rate
These parameter determine the laser pattern’' s height and rate of expansion.
Note: These parameters are only used when either Programmable Raster or
Always Raster is assigned to the “"2D Scanning Mode”" parameter. “"2D Raster
Height”" and “"2D Raster Expand Rate”" are intended for very specific applications
and are usually not required for normal scanning purposes.
Double-tapping on this parameter displays a dialog box in which you can enter a value from
1 to 15.
D.2.4 Data Options —— Decoded (Internal) Scanner
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the
decoded symbol.
When you double-tap on this parameter, a dialog box is displayed in which you can choose a
transmit code: None, AIM or Symbol.
3
WORKABOUT PRO with Windows Mobile 6.1 User Manual
Appendix D: Bar Code Settings
Decoded (Internal) 2D Scanning Options
D-5