Driver Mode Configuration - Psion Teklogix 7527C-G2 User Manual

Note: Your home network operator will need to let you know which other networks have
roaming agreements. Even when a network is listed with an ‘'Available’' status, it does
not necessarily follow that it can be used or that the roaming agreement covers
packet data.
A status of ‘'Forbidden’' indicates that the network cannot be used. If you choose a
network that is not covered by a roaming agreement, the status in the main WWAN
dialog box changes to ‘'Emergency calls only’', ‘'No network found’', ‘'GPRS not avail-
able’' or ‘'GPRS not allowed’'.

6.44.5.4 Driver Mode Configuration

By default, the Wireless WAN driver is enabled (the Enable driver checkbox is checked).
The driver must be disabled in order to access the modem directly (e.g. dial-up data, fax, or
in order to manually submit AT commands to the modem for development, testing, approv-
als, etc.). In most cases, the Virtual WWAN serial port can be used and it is not necessary to
disable the WWAN driver. If the Enable driver checkbox is not checked, the driver is shut
down as soon as the OK button in the Driver Mode dialog box tapped.
If, on the other hand, the Wireless WAN driver is not running and the Enable driver check-
box is checked, the Wireless WAN driver is started as soon the Driver Mode dialog box is
closed using the OK button.
Note: When the driver is not running, no network status or signal strength can be displayed.
Since all currently supported modems are automatically detected, the Enable automatic port
detection checkbox should always be checked. If this checkbox is not checked, a serial port
3
WORKABOUT PRO with Windows Mobile 6.1 User Manual
Chapter 6: Settings
Tools Menu
237