Psion Teklogix 7527C-G2 User Manual page 273

•• Flip the back plate upwards.
•• Insert the flex cable from the WORKABOUT PRO
interface board. The contacts on the flex cable face towards the interface board.
•• Latch the connectors.
•• Cut the Kapton tape square provided in two equal pieces.
•• Remove the Kapton tape from the release liner. Apply one piece over the end of the flex
cable and the imager’'s flex connector. Apply the other piece over the other end of the
flex cable and the back plate flex connector, as shown in Figure 7.1. This secures the
flex cable at both ends.
•• Turn the back plate over.
•• Fasten the new back plate onto the WORKABOUT PRO
(PN 9009770).
•• Switch on the internal power switch in the battery compartment.
•• Insert the battery, and install the battery compartment cover.
Chapter 7: Peripheral Devices & Accessories
The Trigger Back Plate Kit With Flush Mount Pistol Grip
3
3
WORKABOUT PRO with Windows Mobile 6.1 User Manual
main logic board into J1 on the
3
using the supplied screws
255