Psion Teklogix 7527C-G2 User Manual page 272

Chapter 7: Peripheral Devices & Accessories
The Trigger Back Plate Kit With Flush Mount Pistol Grip
Installing The Back Plate
•• If your unit is using AC power, disconnect it.
•• Remove the stylus from the end-cap.
•• Remove the battery pack. Switch off the internal power –– the switch is located inside the
battery compartment.
•• Loosen the four screws securing the end-cap, and remove the end-cap.
•• Unlatch the two connectors on the interface board on the new back plate.
Figure 7.1
•• Position the lower end of the new back plate next to the back opening of the unit.
•• Insert the flex cable from the end-cap into J2 on the interface board. The contacts on the
flex cable face towards the interface board.
Figure 7.2
Tape
•• Latch the connector.
254 WORKABOUT PRO
J1
3
with Windows Mobile 6.1 User Manual
J2
Tape