Manual Mode - h/p/cosmos 150/50 Operating And Service Manual

5.9.2

Manual mode

The following table shows the operating steps for running the treadmill via firmware or software h/p/cosmos para control.
Operation of profile mode
Initiation: Running belt is not moving. One of the modes LED is flashing: (manual, profile, cardio, test)
Step no. Activity
[01] Select manual mode
[02] Start manual mode
[03] Alteration of speed
[04] Alteration of
acceleration/
deceleration level
[05] Pause mode
[06] Alteration of elevation
[07] Switch to the next or
previous mode
[08] Stop running belt
© 2013 h/p/cosmos sports & medical gmbh
Keys Response / Display
Alteration of the mode (manual, profile, cardio, test)
a d
 manual is flashing
until
or
A: standard (in case of deactivation in the optional functions):
c

manual, km/h, m and % are illuminated
met,
energy and power are illuminated alternately
Running belt accelerates up to the pre-selected starting speed
(standard: 0.5 km/h, can be changed in the optional settings),
start of measuring
%
indicates present heart rate: P. 40 ... P. 220. The display indicates every
single heart beat with a flashing dot behind the P.
B: In case of activation in the optional functions:
%
indicates: 65 flashing (for 65 kg body weight),
Enter the actual body weight with
of the POWER and ENERGY consumption.
Further steps see A
Speed is being increased / reduced (0-max)
a d
or
If speed is being reduced to 0, PAUS is displayed
be sustained.
press and hold
Example: to select acceleration level "3", press the corresponding key 3 times
a d
and then hold. (Standard value = 4, maximum 7 levels, may be limited by
or
optional settings)
press and hold
a
PAUS is displayed.
values will be sustained. After restart with d or c all displayed values will be
"added".
Elevation is being increased / reduced (0 ... max.)
f e
or
press and hold
Switch to the next or previous mode.
c d
This is a perfect way to change the mode without stopping the belt.
+
or
c a
+
Running belt stops.
b
(Deceleration time can be adjusted in the optional functions)
Displayed values and selected mode remain for 2 minutes and will then be
deleted (reset) automatically (or after second time pressing the stop button).
file: n:\article\cos14310m5-v1_07hpc-en\20130207_cos14310m5-v1.07hpc-en_h-p-cosmos_treadmill_manual.doc
author: fh email@h-p-cosmos.com
a d c
or , then
=
Running belt stops. All displays stop. Current
.
created 07.02.2013 printed 04.03.2013
operation

weight is illuminated
for an accurate calculation
=.
Current values will
page: 43 of 197