Polar Heart Rate Measurement System - h/p/cosmos 150/50 Operating And Service Manual

12.21 POLAR heart rate measurement system

Stop training immediately if you feel sick or dizzy and consult your doctor.
In the case of interference do not rely on the indicated values of the wireless heart rate
transmission.
Precision of heart rate measuring: + / - 1 %, resp. + / - 1 beat per minute.
Pay attention to the advice regarding safety and warnings about possible interferences in the
chapters on errors, technical data, EMC, and installation in this manual.
WARNING: Heart rate monitoring systems can be inaccurate. Incorrect and/or forbidden use
and/or overtraining can lead to serious injury or even death. If you feel faint, stop training
immediately.
You can use all POLAR transmitters (coded and uncoded) with your running machine. For running machines of
generation MCU 4.0 with firmware version lower than V 3.01.1, an EPROM update is available for the use of coded
transmitters. Note: Even when using the coded senders, the transmission of the heart rate to the treadmill is still un-
coded. The models h/p/cosmos locomotion, h/p/cosmos pulsar, h/p/cosmos venus and h/p/cosmos saturn are equipped
with the POLAR W.I.N.D. transmitter with WearLink technology and coded transmission. The transmitter is only
activated if placed correctly on the body. For correct placement of transmitter belt, see chapter 5 entitled "Operation"
and chapter 5.9.4 entitled "Cardio mode".
© 2013 h/p/cosmos sports & medical gmbh
file: n:\article\cos14310m5-v1_07hpc-en\20130207_cos14310m5-v1.07hpc-en_h-p-cosmos_treadmill_manual.doc
author: fh email@h-p-cosmos.com
accessories and options
Connect the printer (with PCL printer
language and with a serial interface) via
interface cable with the serial interface RS232
of the running machine.
Attention: For a printer with a parallel interface
you will need a commercial interface
converter, available in every computer store,
at your local dealer or from the manufacturer
(h/p/cosmos order no. [cos10056]).
If option 20: 3 is chosen (printer protocol see
list of options), data will be printed out as
shown in the left example.
created 07.02.2013 printed 04.03.2013 page: 174 of 197