Emergency Stop, Stop Buttons, Stop Functions And Safety Features - h/p/cosmos 150/50 Operating And Service Manual

5.4 Emergency Stop, stop buttons, stop functions and safety features

In case of emergency, e.g. danger of stumbling and/or falling, etc., grab the front crossbar and/or both side handrails
and jump onto the foot rails (step platforms) with both feet.
The emergency stop button is to be pressed immediately!
h/p/cosmos is in compliance with the norm EN 957-6 and offers more safety features than required, as shown in the
following tables. In all below mentioned cases, all displayed values will be reset to "0".
Use the emergency stop only if in danger.
N
The emergency stop is not to be used as a normal stop key.
N
Type of Stop
Safety Stop =
Emergency Stop
on UserTerminal
Safety Stop =
Emergency Stop
Quick Stop
models venus / saturn
Emergency stop
button is connected to
the "quick stop port"
of the UserTerminal
© 2013 h/p/cosmos sports & medical gmbh
Function
palm switch is hit
N
running belt & inclination system stop fast
N
machine is cut off from main power of
N
drive motor and inclination system
display, keyboard and interface inactive
N
mushroom switch is hit
N
running belt & inclination system stop fast
N
machine is cut off from main power of
N
drive motor and inclination system
display, keyboard and interface inactive
N
mushroom switch is hit
N
running belt & inclination system stop
N
extremely fast
drive motor is used to stop the running belt
N
very fast
machine is NOT cut off from main power
N
of drive motor and inclination system
display active, shows "PULL STOP"
N
interface active, but no start, speed or
N
elevation signal executed
keyboard inactive
N
file: n:\article\cos14310m5-v1_07hpc-en\20130207_cos14310m5-v1.07hpc-en_h-p-cosmos_treadmill_manual.doc
author: fh email@h-p-cosmos.com
Interface
How to restart
communication
interrupted
N
N
during cut-off
from main power
N
N
or new command via
interface
interrupted
N
N
during cut-off
N
from
main power
N
or new command via
interface
NOT
N
interrupted
N
during
N
Quick Stop
stage or new command via
interface
created 07.02.2013 printed 04.03.2013 page: 30 of 197
operation
wait 1 minute
turn palm switch to
the right
push "ON" button at
main power switch
press START key at
UserTerminal
wait 1 minute
pull mushroom switch
push "ON" button at
main power switch
press START key at
UserTerminal
pull mushroom switch
„pull-stop" advice
stays for 10 seconds
press START key at
UserTerminal