Konica Minolta bizhub Pro 920 User Manual page 694

18
9
Touch [Connect Confirm] to check that the machine is connected to
the LDAP server.
If connection error occurs, a popup menu will be displayed.
– The [Connect Confirm] key will not be displayed if LDAP Function is
set to [Not Use], or Registering and Changing Address of Prohibit
User Operation is set to [Restrict].
– The settings of Setting Up LDAP Screen can be reset to the factory
initial setting.
Touch [Reset All] to display the popup menu for confirmation, then
touch [Yes] to reset all the setting, or touch [No] to cancel.
10
Touch [OK] to complete the setting and return to the LDAP Setting
Screen.
If further changes are required, touch the desired key.
11
After you have changed the settings, turn off the sub power, then turn
off and on the main power.
Reminder
When you turn off and on the main power, you need to wait at least 10
seconds to turn on after turning off. If you do not allow a sufficient interval
in between, the machine may not run correctly.
Reminder
Be sure to correctly specify the LDAP server setting, otherwise you may
have trouble with the network. This setting should be performed by the
server administrator.
If the port number is improperly changed, you may have trouble with the
network. Be sure not to change the port number unless the network ad-
ministrator gives instruction to do so.
18-174
Utility <Administrator Setting>
bizhub PRO 920