Konica Minolta bizhub Pro 920 User Manual page 6

The Control Software version is as follows
(This software consists of Image control program and Controller control pro-
gram.)
Image control program (Image Control l1) version: 10-0000, 20-0000 or later
Controller control program (IP Control P) version: 10-0000, 20-0000 or later
About the Firmware version display function
The bizhub PRO 920 Control Software (Image control program / Controller
control program) version mentioned above can be confirmed by using the
service representative (CE) service mode firmware version display function.
When you display the firmware version, the Image control program and Con-
troller control program versions will be displayed as follows.
Image control program (Image Control l1) version:
2 digits + 4 zeros following the hyphen (Ex: 10-0000)
Controller control program (IP Control P) version:
2 digits + 4 zeros following the hyphen (Ex: 10-0000)
Please keep this in mind when checking the software version.
ACKNOWLEDGEMENTS:
KONICA MINOLTA, KONICA MINOLTA Logo, and The essentials of imaging
are registered trademarks or trademarks of KONICA MINOLTA HOLDINGS,
INC.
PageScope and bizhub PRO are registered trademarks or trademarks of
KONICA MINOLTA BUSINESS TECHNOLOGIES, INC.
Copyright © 2005 KONICA MINOLTA BUSINESS TECHNOLOGIES, Inc.
EXEMPTION
- No part of this manual may be used or duplicated without permission.
- Manufacturer and Sales Company will have no liability for any influences
caused by using the printing system and this User's Guide.
- The information written in this User's Guide is subject to change without
prior notice.
x-4 bizhub PRO 920