Using Finisher Manually - Konica Minolta bizhub Pro 920 User Manual

12

12.10 Using Finisher Manually

The Finisher FS-509/FS-604 with Post inserter PI-501 installed can be oper-
ated manually, using the operation panel provided on the post inserter.
Place a set of paper into the lower tray. Upper tray cannot be used.
Available finishing modes according to the optional configuration are de-
scribed below.
- Finisher FS-509 + Post inserter PI-501
– Staple (1 staple / 2 staples)
- Finisher FS-604 + Post inserter PI-501
– Staple (1 staple / 2 staples)
– Fold&Staple
– Letter Fold
- Finisher FS-509 + Post inserter PI-501 + Punch kit PK-504/505
– Staple (1 staple / 2 staples)
– Punch
- Finisher FS-604 + Post inserter PI-501 + Punch kit PK-504/505
– Staple (1 staple / 2 staples)
– Fold&Staple
– Letter Fold
– Punch
Reminder
The Z folding unit ZU-601/602 cannot be used for manual punch. To use
Punch mode manually, Punch kit PK-504/505 is necessary.
Fold&Staple
1 oblique staple
12-30
2 parallel staples
Letter Fold
Finishing / Paper Fold
Start/Stop button
Punch
bizhub PRO 920