Using Finisher Manually - Konica Minolta BIZHUB 750 User Manual

Basic copy operations
4.13

Using finisher manually

The Finisher FS-504/FS-505/FS-602 with Post Inserter PI-501 installed can
be operated manually, using the operation panel provided on the Post
Inserter.
Place a set of paper into the lower tray. Upper tray cannot be used.
Available finishing modes according to the optional configuration are
described below.
- Finisher FS-504 + Post Inserter PI-501
– Staple (Corner staple / 2 position staples)
- Finisher FS-602 + Post Inserter PI-501
– Staple (Corner staple / 2 position staples)
– Fold&Staple
– Tri-Fold
- Finisher FS-509 + Post Inserter PI-501 + Punch kit PK-504/505
– Staple (Corner staple / 2 position staples)
– Punch
- Finisher FS-604 + Post Inserter PI-501 + Punch kit PK-504/505
– Staple (Corner staple / 2 position staples)
– Fold&Staple
– Tri-Fold
– Punch
- Finisher FS-505 + Post Inserter PI-501
– Staple (Corner staple / 2 position staples)
- Finisher FS-505 + Post Inserter PI-501 + Punch kit PK-504/505
– Staple (Corner staple / 2 position staples)
– Punch
Reminder
The Z folding unit ZU-601/602 cannot be used for manual punch. To use
Punch mode manually, Punch kit PK-504/505 is necessary.
bizhub 750/600 (Phase 2)
4
4-95