Omron SYSDRIVE RX Series User Manual page 204

4-2 Function Mode
Signal During RUN
•While the Inverter is running, this signal is output via multi-function output terminals P1 to P5 or the
relay output terminal.
•Allocate "00" (RUN) to any of multi-function output terminals P1 to P5 (C021 to C025) or the relay
output terminal (C026).
•This signal is also output during DC injection braking.
Below is the time chart.
4
Frequency Arrival Signal
•When the output frequency reaches the set level, a frequency arrival signal is output.
Parameter
No.
Arrival frequency during
C042
Arrival frequency during
C045
Arrival frequency during
C043
Arrival frequency during
C046
•For elevating machines, use this signal for applying the brake. To release the brake, use the
overtorque signal.
•Allocate "01" (FA1: Constant speed arrival signal), "02" (FA2: Set frequency exceeded), "06" (FA3:
Set frequency only), "24" (FA4: Set frequency exceeded 2), or "25" (FA5: Set frequency only 2) to
any of multi-function output terminals P1 to P5 (C021 to C025) or the relay output terminal (C026).
•Below is the hysteresis of the frequency arrival signal:
ON: (Set frequency - 1% of the maximum frequency) (Hz)
OFF: (Set frequency - 2% of the maximum frequency) (Hz)
If "06" (FA3) or "25" (FA5) is set, however, operation during acceleration is:
ON: (Set frequency - 1% of the maximum frequency) (Hz)
OFF: (Set frequency + 2% of the maximum frequency) (Hz)
and operation during deceleration is:
ON: (Set frequency + 1% of the maximum frequency) (Hz)
OFF: (Set frequency - 2% of the maximum frequency) (Hz)
4-95
Output frequency
FW
RUN
Function name
acceleration
0.0: Does not output arrival signal during acceleration.
0.1 to 400.0: Outputs arrival signal during acceleration.
acceleration 2
deceleration
0.0: Does not output arrival signal during deceleration.
0.1 to 400.0: Outputs arrival signal during deceleration.
deceleration 2
Data
Default
Unit
setting
0.0 Hz
0.0 Hz