Setting Address(Id) Of Dome Camera - Honeywell ScanDome II HSDN-251NS/PS Operation & Programming Manual

Cable for communication
Enable Termination (On)
Cable for communication
2.4 Setting Address (ID) of Dome Camera
To prevent damage, each dome camera must have a unique address (ID). When installing
multiple dome cameras using a multiplexer, it is suggested that the dome camera address match
the multiplexer port number.
Example: Port 1 = Dome 1, Port 2 = Dome 2 "
cameras are installed using two or more multiplexers, ID of the dome camera should be ID of
MUX x No. of camera IN. (e.g. multiplexer ID= n, Camera IN= m then ID of Dome =16x(n-1)+m )
Refer to Figures 3-4 for setting the dome camera address (ID) and protocol selection.
Figure 6 Termination Diagram
D ID
OME
1
2
.
999
Figure 7• Setting Address (ID) of Dome Camera
Enable Termination (On)
Port 16 = Dome 16. If more than 16 dome
SW1 SW2
0 0
0 0
. .
9 9
6
rd
3 Branch Not allowed
Without spliter /repeater
SW3
1
2
.
9