Configuring Sectors; Programming A Sector; Changing A Sector Name Location On The Monitor; Turning Sector Id Titles On Or Off - Honeywell ACUIX Installation And Configuration Manual

Configuring Sectors

Task/Action (with Default)

Programming a Sector

1. Select 2 Display Options
Sector title display.
2. Select 6 Function Programming
3. Select a Sector ID number to program. Press Iris Open (+).
4. Using the joystick to scroll through the list of numbers and
letters, enter a 24-alphanumeric name for the sector. Press Iris
Open (+).
The instructions Go to lower left corner and press
Iris Open when done display.
5. Press Focus Far (-) to switch to PTZ mode to gain control over
the joystick and position the picture to the lower left corner of
the sector.
6. Press Focus Near (+) to switch to menu mode to access the
controller keyboard. Press Iris Open (+).
The instructions Go to upper right corner and press
Iris Open when done display.
7. Press Focus Far (-) to switch to PTZ mode to gain control over
the joystick and position the picture to the upper right corner of
the sector.
8. Press Focus Near (+) to switch to menu mode to access the
controller keyboard.
9. Press Iris Open (+)
the sector, program another sector or exit.

Changing a Sector Name Location on the Monitor

• Select 2 Display Options
Use either arrows or the joystick to move the text up or down
the monitor to position as required.

Turning Sector ID Titles ON or OFF

• Select 2 Display Options
Document 800-05662 Rev C
06/10
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
Note Remember you access the OSD by pressing 90
 
2 Sectors ON to turn on the

5 Program Sector.
 
Focus Far (-) Iris Close (-) to save

7 Change Sector Name Loc
 
2 Sectors ON or OFF (default).

Notes
This menu is available only when using
MAXPRO-mode, VCL, UTP and Pelco P
and D protocols

If the dome has overlapping sectors
displaying at the same time, the two titles
alternate at 1.5 second intervals.
Preset.
105