Step 5: Install The Trim Ring Or Cover And The Lower Dome - Honeywell ACUIX ES Installation Manual

TM
Installing the ACUIX ES Fixed Camera

Step 5: Install the Trim Ring or Cover and the Lower Dome

20
Smoked lower domes only: In order to ensure maximum illumination, the light colored
area through the center of the lower dome must be oriented correctly over the lens as
in Figure 11.
Installing the Lower Dome on Surface Mount or Indoor Pendant
1. For both pendant and surface mount installations, align the three hooks on the
housing cover with the three holes on the inside of the top cap or skirt. Rotate the
housing cover until it is secure inside the top cap or skirt. See
2. Smoked domes only: Rotate the lower dome so that the clear slot that runs down the
center faces the front of the camera and is aligned with the camera lens. See
Figure 11.
3. Align the two holes on the lower dome with the two screw holes on either side of the
gimbal. Use the two screws provided to secure the lower dome to the gimbal.
Figure 11 Smoked Lower Dome Orientation Over the Lens
Installing the Lower Dome on an In-Ceiling
1. Insert the trim ring into the inside of the housing and rotate it until the three hooks on
the trim ring are aligned and secure underneath the three round tabs. See
2. Smoked domes only: Rotate the lower dome so that the clear slot that runs down the
center faces the front of the camera and is aligned with the camera lens. See
Figure 11.
3. Align the two holes on the lower dome with the two holes on either side of the gimbal.
4. Use the screws provided to secure the lower dome to the gimbal.
Figure 2.
Align the clear center strip in
front of the lens to maximize
illumination when installing
a smoked lower dome
Figure 4.