Limiting The Time That A Unit Can Be Used; Limiting The Use Of Cameras And Other Devices By Partitioning; Figure 10-8 Setting An Account's Session Time Limit - Honeywell Rapid Eye System Administration Manual

TIP!

Limiting the Time that a Unit Can Be Used

Select the sites
that can be
accessed by
the user

Limiting the Use of Cameras and Other Devices by Partitioning

TIP!
Document 800-07769 Rev A
02/11
6. Update security at each site you have denied access to. The procedure to update
security is in
Updating Security on a Multi-Media Unit
Why deny or limit access to a site?
This depends on your organization's security protocols. An operator might be allowed
to monitor only some sites, and so on.
Figure 10-8 Setting an Account's Session Time Limit
Select the Time limit option and set the number of minutes that the user can access the sites
for (see 10-8, above).
Figure
You can also set the default time limit for new users on the Options dialog box of the Admin
application (see 11-9). Select View
Figure
Options dialog box. Select the Default time limit of a new User (in minutes) checkbox
and then adjust the minutes as needed with the up and down arrows (
You can deny access to some or all devices at a site (including cameras and POS devices).
By default, a user account can access every camera at a site.
Why deny access to a device? This depends on your organization's security
protocols. Perhaps an operator should only monitor some cameras, and not others.
Rapid Eye DVR System Administrator Guide
on page 141.
Select to limit site
access time

Options in the Admin application to open the
).
199