Behavior Of Ptz After A Session Closes; Figure 6-10 Ptz Camera: Behavior After Use - Honeywell Rapid Eye System Administration Manual

Behavior of PTZ After a Session Closes

Set the actions the PTZ takes
when a live session closes. The
PTZ can: go to a Preset, stay put,
start a tour, and return to Auto Iris
and Auto Focus settings.
Document 800-07769 Rev A
02/11
PTZ and Motion Detection
When an alarm based on motion detection is enabled on a PTZ camera, use of PTZ
functions will most likely trigger that alarm. You can limit the number of alarms triggered by
using the Delay slider in the motion detection controls. The alarm schedule can also be
changed to stop alarms at certain times, such as when PTZ use is anticipated. See
on page and
Detection 125
Ultrak KD6i Domes
Before an aperture setting can be changed manually on an Ultrak KD6i dome, you need to
turn OFF the auto-aperture option. Auto-aperture is also known as auto-iris on the PTZ
controller.
The Return to auto-focus command has no effect on Ultrak KD6i domes.
Kalatel Domes
On Kalatel domes, the iris controls in View toggles harsh brighter/darker settings, not a
gradual open or close. Auto-iris has no effect.
Position of PTZ Camera
When a Live Session ends, a security officer may need a PTZ camera to return to a set
position and zoom value, while the camera is not being monitored by a View operator.
Figure 6-10 PTZ Camera: Behavior After Use
1. Using View, continue or start a
camera(s) need their post-session behavior set.
2. Click the Video tab.
3. Click PTZ. Check if the Enable box is selected. Post-session behavior cannot be set
unless PTZ is enabled.
Rapid Eye DVR System Administrator Guide
on page
Events Defined 203
Maintenance Session
Motion
for more information.
at a site where pan, tilt and zoom
101