Ir Remote Control - Eneo DLR-2116 Quick User Manual

IR Remote Control

ID Button
Camera Buttons
Sequence Button
Freeze Button
Arrow Buttons
Menu Button
If a DVR System ID is set to 0, the infrared remote control will control that DVR without
any additional operations. If the system ID is 1 to 16, you must to press the
and then press the number button (1 to 16 (+10 & 6)) in order to control that DVR. If
the System ID of two or more DVRs is set to 0, those DVRs will react to the infrared
remote control at the same time.
Pressing the individual camera buttons will cause the selected camera to display full
screen. Buttons are also used to enter passwords.
When in the Live Monitoring mode, pressing the
sequentially.
Pressing the button freezes the current live screen.
FREEZE
These buttons are used to navigate through menus and GUI. You can also use them to
change numbers by highlighting a number in the menu and using the Up and Down arrow
buttons to increase or decrease the number's value. These buttons are also used to control
Pan and Tilt when in the PTZ mode.
When in the PIP display format, pressing the Up and Down arrow buttons moves the
position of the small screen counter-clockwise and clockwise.
Pressing the Left and Right buttons moves through screen pages in the Live Monitoring
mode and Search mode.
In the Live Monitoring mode and Search mode, pressing the
menu icons on the right edge of the screen. Pressing the button again hides the menu
icons. During menu setup, pressing the button closes the current menu or setup dialog box.
ID Button
Camera Buttons
Sequence Button
Freeze Button
Arrow Buttons
Menu Button
Playback Buttons
Panic Button
Layout Button
Zoom Button
PTZ Button
Enter Button
Alarm Button
PTZ Control Buttons
Back Up Button
Calendar Button
button displays live channels
SEQUENCE
button displays the
MENU
button
ID
11