Calibrate The Ils; Present Movies; Connecting Sources; Using An Anamorphic Lens - Christie CP2220 User Manual

Section 5: Operation

5.6.6 Calibrate the ILS

You must calibrate the ILS must when you install a new lens.
1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Full Calibration. If Enable Automatic ILS is not selected, the lens returns to the stored settings.
5.7

Present Movies

This section provides information and procedures for using the projector to present movies. It is recommended
that you read through this section in its entirety before displaying movies for the first time. Before you display
movies for the first time, verify that the projector is properly installed, aligned, and configured. See
Installation and
5.7.1

Connecting Sources

Connect a digital media storage device or cinema server to one of the 292A or 292B input ports. For a list of
standard single-link SMPTE 292M Formats, see
5.7.2

Using an Anamorphic Lens

The standard zoom lens on the projector can display flat images because the native resolution and format of the
projector closely match the flat aspect ratio. The installation of an optional anamorphic lens requires that the
source material is resized to fill the digital micromirror device (DMD) and the pixels are horizontally stretched
so that the full 2.39 image width appears on-screen.
Figure 5-2 Using Anamorphic Lens to Achieve "Scope" for Large Screens
5.7.3

Using a Wide Converter Lens

The optional Wide Converter Lens (WCL) magnifies a flat image with a format of 1.85:1 to a scope image with
a 2.39:1 format, while maintaining the full resolution of the source material.
Figure 5-3 Using Wide Converter Lens to Achieve "Scope" with No Resizing
5-6
Setup.
Appendix A: Specifications.
2
CP2220 User Manual
020-100420-07 Rev.1 (1-2012)