Calibrate The Ils; Present Movies; Connecting Sources; Using An Anamorphic Lens - Christie CP2220 User Manual

Section 5: Operation

5.6.6 Calibrate the ILS

You must calibrate the ILS must when you install a new lens.
1. On the Main screen of the TPC, tap Lens Adjust.
2. Tap Full Calibration. If Enable Automatic ILS is not selected, the lens returns to the stored settings.
5.7

Present Movies

This section provides information and procedures for using the cinema projector to present movies. It is
recommended that you read through this section in its entirety before displaying movies for the first time.
Before you display movies for the first time, verify that the cinema projector is properly installed, aligned, and
configured. See
5.7.1

Connecting Sources

Connect a digital media storage device or cinema server to one of the 292A or 292B input ports. For a list of
standard single-link SMPTE 292M Formats, see
5.7.2

Using an Anamorphic Lens

The standard zoom lens on the cinema projector can display flat images because the native resolution and
format of the cinema projector closely match the flat aspect ratio. The installation of an optional anamorphic
lens requires that the source material is resized to fill the digital micromirror device (DMD) and the pixels are
horizontally stretched so that the full 2.39 image width appears on-screen.
Figure 5-2 Using Anamorphic Lens to Achieve "Scope" for Large Screens
5.7.3

Using a Wide Converter Lens

The optional Wide Converter Lens (WCL) magnifies a flat image with a format of 1.85:1 to a scope image
with a 2.39:1 format, while maintaining the full resolution of the source material.
Figure 5-3 Using Wide Converter Lens to Achieve "Scope" with No Resizing
5-6
2 Installation and Setup.
Appendix A: Specifications.
CP2220 User Manual
020-100420-08 Rev.1 (5-2014)