Table of Contents
Advertisement
6. Install the rear mount support brackets at the rear of the server, extending the
rear mount support brackets to the measured depth of the rack.
Use two to three of the supplied M4 x 0.5 x 5 mm panhead Phillips screws for each
bracket, depending on the rack depth.
7. Lift the server to the desired location in the rack.
8. Using two screws per side, secure the front of the hardmount brackets that are
attached to the sides of the server.
9. Using two screws for each rear mount support bracket, secure the rear mount
support brackets to the rear of the rack.
Installing the Server in a 4-Post Rack
31
Advertisement
Table of Contents
