Install A Server (2-Post, 19-Inch Sliding-Rail Kit) - Oracle Netra Server X3-2 Installation Manual

19-Inch Sliding-Rail Screws
TABLE:
Quantity Description
10 M4 x 0.5 mm x 5 mm Phillips panhead screws
10 M5 x 12.7 mm screws
12 M6 x 13 mm screws
9 M6 square clip nuts
10 10–32 collar screws, 4 short, 4 long, 2 extra
12 10–32 x 0.5 in. combo head screws
12 12–24 x 0.5 in. combo head screws
Related Information
"Install a Server (2-Post, 19-Inch Sliding-Rail Kit)" on page 61
■
"Tools Needed for Installation" on page 22
■
"Handling Precautions" on page 20
■
"Rack Cautions" on page 23
■

▼ Install a Server (2-Post, 19-Inch Sliding-Rail Kit)

Note – The 19-inch, 2-post sliding rail mount kit supports rack web thicknesses (the
width of the rack post) of 3 in. (76.20 mm), 4 in. (101.6 mm), and 5 in. (127 mm).
Note – The front-to-back rail spacing must be at least 15.43 in. (392 mm) and not
more than 34 in. (863.6 mm) from the outside face of the front rail to the outside face
of the back rail.
1. Gather the required tools.
See
2. Read the server cautions.
See
3. Read the rack cautions and stabilize the rack.
See
"Tools Needed for Installation" on page
"Handling Precautions" on page 20
"Rack Cautions" on page 23
Where Used
8 for glides, 2 extra
10 for rack, if appropriate
10 for rack, 2 extra
9 for rack, if appropriate
8 for racks with 10-32 holes, if appropriate
12 for rack, if appropriate
12 for rack, if appropriate
22.
and "ESD Precautions" on page
and "Stabilize the Rack" on page
Installing the Server in a 2-Post Rack
21.
24.
61