Lamploc™ Setup Window - Christie CP2220 User Manual

6.13.3 LampLOC™ Setup Window
Use the LampLOC Setup window to reposition the projector bulb for optimized light output. Tap Menu >
Advanced Setup > LampLOC™ Setup
Click Do Auto to run LampLOC automatically. You must turn the lamp on before you run LampLOC. If you
turn the lamp off during LampLOC, the bulb returns to its former position. The douser is open and it is not
functional during a LampLOC adjustment. To keep the bulb optimized as it ages, run LampLOC once a month
Figure 6-20 Advanced Setup: LampLOC™ Setup Window
Table 6.15 Advanced Setup: LampLOC™ Setup Window
Control
Left/Right
Up/Down
In/Out Arrow
Buttons
Value
Light Bar
Do Auto
Display Full
Screen White
Test Pattern
CP2220 User Manual
020-100420-07 Rev.1 (1-2012)
1
3
Description
Moves the lamp up, down, in, out, left, and right. The current position of the lamp displays in Cartesian
coordinates. Tap once to increase or decrease the lamp position by a single increment. Press and hold a
button to increase or decrease the lamp position by multiple increments. You cannot move the lamp
beyond the pre-defined limits for the projector. For CP2210, X/Y = +/-250; Z = +/-175.
Shows the current light sensor reading in arbitrary units-of -measure and does not represent actual
lumens or fL.
Indicates the current light intensity (vertical bar) and LiteLOC
Starts the auto LampLOC calibration procedure, which adjusts the lamp position until the highest light
™
reading is obtained from the light sensor.
Temporarily displays a full screen white test pattern for the duration of the LampLOC™ adjustment.
The previous display reappears when you close the LampLOC™ Setup page or clear the check box.
Section 6: Projector Menus
2
LiteLOC™
Target
Light
Intensity
™ target (red horizontal line).
.
6-27