Front Panel Power Led And Fan Led Combination; System Specifications - Cisco Network Convergence System 540 Hardware Installation Manual

Front Panel Power LED and Fan LED Combination

POWER LED
Green 1Hz
flashing
Off
Amber
Front Panel Power LED and Fan LED Combination
Table 12: Front Panel Power LED and Fan LED Combination
Fan LED
Off
—
Green
Flashing Red
Flashing Red
Flashing Amber
Flashing Amber
Flashing Amber
Flashing Green
Off

System Specifications

For information on the system specifications, see the Cisco Network Convergence System Large Density 540
Routers Data Sheet.
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
70
FAIL LED Power Supply Condition
Off Power supply is not plugged in to the chassis or shutdown by the
system.
Off No valid power input.
Off Low input voltage.
Power LED
Red
Amber
Flashing Amber
Flashing Red
Flashing Amber
Flashing Green
Flashing Red
Flashing Amber
Flashing Green
Green
Status
Power failure with one of the input power
feeds failed or one of the on-board voltage
rails has failed.
STDBY FPGA upgrade is in progress due to
post Reload/Power cycle after HW FPD
upgrade All.
Upgrade of the STDBY FPGA
Note
takes 3–5 minutes.
Thermal shutdown with no fan
Thermal shutdown
MSS Ready=0
TAM init fail
TAM Not Ready
SECURE JTAG Fail
BIOS Validation Failure
Power Supply ON and operating normally.
Appendix