Table of Contents
Advertisement
Hard Disk Drive Module
The hard disk drive module is the removable metal framework which
holds up to four hard disk drives. The server's disk subsystem can
accommodate up to five of these modules. Removal of a module will
usually only be necessary if the circuit boards on the module backplane
fail.
Note
Ensure that both side panels are removed before attempting to remove or fit a drive
module.
Removing
1.
Remove all hard disk drives which may be fitted to the module in
question (see "Hard Disk Drive, Removing", earlier in this chapter).
2.
In the electronics chamber, unplug the data ribbon cable from the
connector on the back of the module. The connector is visible
through an opening in the centre spine.
Figure 4-6 Unplugging Ribbon Cable from Module Data Connector
1.
Hard Disk Module Data
Connector
S e r v i c e I n f o r m a t i o n
1
2
2.
Ribbon Cable
OWNER'S HANDBOOK 4-7
Advertisement
Table of Contents
