Table of Contents
Advertisement
3.
Tilt the top of the assembly slightly towards the interior of the
server (if it hasn't already) and lift it upwards to free it from the
chassis.
Figure 4-30 SMC Fan Assembly
1.
Tab Slots
Fitting
1.
Fit the assembly so that the two metal tabs at the bottom are
inserted into corresponding slots. The assembly will then have a
natural tilt towards the interior of the server.
2.
On each side of the assembly there is also a smaller tab which fits
into a corresponding slot in the chassis. Squeeze the sides gently
until the tabs fit into the slots.
3.
While holding the assembly in place, fasten it with the two screws
on the back panel of the server.
4.
Connect the fan cable to the top connector on the controller board
(see fan connector graphic in "System Management Controller
Board, Fitting").
S e r v i c e I n f o r m a t i o n
2
2.
Metal Tabs
OWNER'S HANDBOOK 4-29
1
Advertisement
Table of Contents
