Table of Contents
Advertisement
Fitting
1.
Locate an empty drive tray. It may be wise to keep a written record
of which trays are fitted with drives. You can identify a specific
drive by observing the labelling scheme as shown in the following
illustration:
1
2
3
4
Figure 4-4 Disk Subsystem Labelling Scheme
In addition to the external labelling scheme, each SCSI drive,
including the appropriate removable media drives, is assigned a
SCSI identification number. The ID scheme for each hard disk drive
module, labelled A-E, is the same. The following table indicates
these numbers:
Drive
Hard Disk, Position 1
Hard Disk, Position 2
Hard Disk, Position 3
Hard Disk, Position 4
CD-ROM Drive
1st Tape Backup Drive
2nd Tape Backup Drive
Your system displays these numbers during Power On Self Test
(POST).
2.
To remove an empty tray, turn the release handle anti-clockwise
until it stops, which is almost one complete turn. As you turn the
handle, the tray ejects slightly.
A
B
C
S e r v i c e I n f o r m a t i o n
D
E
SCSI ID Number
0
1
3
4
5
2
6
OWNER'S HANDBOOK 4-5
Advertisement
Table of Contents
