Installing Hard Disk Drives - Mitsubishi Electric Apricot LS700 Owner's Handbook Manual

Installing a floppy Diskette Drive

Installing Hard Disk Drives

Installing a hard disk drive in the floppy Drive Carrier
1. Observe the precautions in 'Before You Begin'.
2. Remove the diskette drive carrier.
3. Remove the diskette drive from its protective wrapper
and place it on an antistatic surface.
4. Set any jumpers or switches on the drive according to
the manufacturer's instructions.
5. Slide the diskette drive into the drive carrier. Line the
holes on the carrier up with the screw holes on the
drive.
6. Insert and tighten three screws of the appropriate type
and length (not supplied).
7. Install the drive carrier back into the chassis.
8. Attach the power cable and the data cable to the drive.
1. Observe the precautions in 'Before You Begin'.
2. Remove the floppy drive carrier.
3. Remove the drive from its protective wrapper and place
it on an antistatic surface.
4. Set any jumpers, switches, or terminating resistors on
the drive according to the manufacturer's instructions.
5. Slide the drive into the drive carrier. Line the holes on
the carrier up with the screw holes on the drive.
6. Insert and tighten three screws of the appropriate type
and length (not supplied).
7. Install the drive carrier back into the chassis.
8. Attach the power cable and the data cable to the drive.
C h a s s i s a n d c o m p o n e n t s
LS700 HANDBOOK 2/15