Mitsubishi Electric Apricot Owner's Handbook Manual page 36

Computer
Hide thumbs Also See for Apricot:
Table of Contents

Advertisement

U p g r a d i n g Y o u r S y s t e m
You can fit either one or two of both kinds of cards. The CPU card can
contain either single or dual processors and can be fitted in the following
configurations:
One single card
Two single cards
One dual card
Two dual cards
If you have only one CPU card, either single or dual, it should aways be
fitted in CPU slot 1. Similarly, if you only have one memory card, it
should be fitted in Memory slot 1.
The installation procedure for both kinds of cards is essentially the same:
1.
Remove the metal stabilizer strap, which corresponds to the slot in
question, from the chassis. There are four of these straps, one for
each memory slot and each CPU slot.
2.
Insert the card connector strip into the slot with the component side
of the card facing down. Ensure that the connector is firmly seated,
but do not use excessive force.
3.
Insert the tabbed end of the stabilizer strap into its corresponding
slot in the cooling fan assembly metalwork. Then fit the strap's
groove over the edge of the card and use the screw to fasten the
other end to the chassis. The card should now be securely fixed in
position.
4.
Run the System Configuration Utility (see chapter 2, Operating Your
System, for instructions).
3-6 OWNER'S HANDBOOK

Advertisement

Table of Contents
loading

Table of Contents