Table of Contents
Advertisement
S e r v i c e I n f o r m a t i o n
Fitting
1.
Slide the assembly into position, remembering to feed the guide tabs
into the positioning slots as shown in the following illustration:
1
Figure 4-34 Refitting Hard Disk Cooling Fan Assembly
1.
Positioning Slots
2.
Guide Tabs
2.
At the same time, feed the fan cables through the cutout in the
corner of the metalwork above the assembly. These cables will need
to be plugged into their respective sockets on the SMC board.
3.
Fasten the assembly to the chassis with the two screws.
4-34 OWNER'S HANDBOOK
2
2
3.
Securing Screws
3
Advertisement
Table of Contents
