Table of Contents
Advertisement
S e r v i c e I n f o r m a t i o n
3.
Now grasp the front plate of the drive tray and pull it out carefully
until the tray is free of the metalwork.
4.
Place the drive into the tray, turn the tray over and fasten the drive
onto it by means of the four screws as shown:
Figure 4-5 Hard Disk Drive Tray Securing Screws
1.
Securing Screws
5.
Ensure that the release handle on the tray is turned anti-clockwise as
far as it will go.
6.
Insert the tray carefully back into the drive module and push it in
until it reaches the point where the hard disk release handle will
engage. You must not knock or jolt the hard disk drive.
7.
Turn the hard disk release handle clockwise almost one complete
turn until the tray metalwork is flush with the drive module. During
this procedure the hard disk plugs into the SCSI connector on the
drive module backplane.
Note
Since the hard disk drives for your Apricot are exclusively SCSI drives, it is
important to note that the SCSI connector on the backplane of the drive module
contains the device address. This means that, for a given connector, any disk drive
that is fitted to that connector will have the same SCSI address.
4-6 OWNER'S HANDBOOK
1
2
2.
Disk Drive Tray
Advertisement
Table of Contents
