Table of Contents
Advertisement
Removing
Each drive is attached to a drive tray, which is in turn secured to a drive
cage. To remove a tray from the cage:
1.
Unplug the data and power cables from the rear of the drive.
Unplug the other end of the power cable from its socket on the
centre spine.
2.
Remove the two drive tray securing screws from the side of the
cage. The following diagram shows the screws for three of the
drives:
1
Figure 4-22 Removable Media Drive Bay (Internal)
1.
Drive Tray Securing Screws
2.
Drive Power Cables
3.
Slide the tray carefully toward the rear of the cage until it is free
from the metalwork.
S e r v i c e I n f o r m a t i o n
2
3.
Drive Data Cables
OWNER'S HANDBOOK 4-21
3
Advertisement
Table of Contents
