Table of Contents
Advertisement
Fitting
Caution
Before attempting to fit the fan onto the fan assembly housing, be sure to place the
fan into the assembly so that the air flow through it is from the front of the server to
the rear (see the arrow next to the electrical polarity marking on one corner of the
fan). If any fan is turned the wrong way around, it will seriously reduce the overall
cooling effectiveness and increase the risk of overheating.
1.
With the housing upright, align one corner of the handguard with a
screw hole and insert a screw.
2.
While holding the handguard and screw in place, align the fan in a
similar way and tighten the screw. Then align and fit the remaining
three screws.
S e r v i c e I n f o r m a t i o n
OWNER'S HANDBOOK 4-31
Advertisement
Table of Contents
