Table of Contents
Advertisement
S e r v i c e I n f o r m a t i o n
3.
Turn the drive upright, slide it into the drive cage and secure it to
the cage using the two screws. The following illustration shows the
securing screws for three of the drive trays:
1
Figure 4-25 Removable Media Drive Bay (Internal)
1.
Securing Screws
2.
Drive Power Cables
4.
Connect the power cable to the back of the drive and the other end
to the socket on the centre spine.
5.
If you are fitting a SCSI drive, you will need to connect it to the bus
cable which is attached to any other SCSI removable media drives
that are present. If there are no more SCSI devices, connect the
cable directly into the connector at the top of hard disk drive
module B.
Note
The drive tray securing screws allow a small amount of horizontal adjustment to
enable you to ensure that the front of a drive is exactly flush with the front
metalwork. If the fitted drive protrudes beyond the metalwork, the drive bay door
may not be able to close.
4-24 OWNER'S HANDBOOK
2
3.
Drive Data Cables
3
Advertisement
Table of Contents
