Table of Contents
Advertisement
Fitting
1.
Attach the motherboard to the centre spine of the server using the
14 screws as shown in the following illustration:
2
Figure 4-43 Motherboard Securing Screws
1.
Motherboard
2.
Reconnect the hard disk cables from the drive modules to the
appropriate connectors as they were originally.
Caution
Be absolutely sure that you restore the hard disk cable and connector arrangement as
it was originally, particularly if you have a RAID configuration. Failure to do so
will cause massive data loss.
3.
Plug the Floppy Drive and Front Panel cables into their respective
connectors.
S e r v i c e I n f o r m a t i o n
1
2.
Securing Screws
OWNER'S HANDBOOK 4-45
2
Advertisement
Table of Contents
