Table of Contents
Advertisement
S e r v i c e I n f o r m a t i o n
3.
In the electronics chamber, attach the three bus bars as shown:
2
Figure 4-50 Bus Bars Connected to Hard Disk Power Distribution Panel
Note
You must use a torque wrench to tighten the bus bar bolts. The torque wrench setting
is 5 newton metres (Nm).
1.
Bus Bars
4.
Replace the motherboard cooling fan assembly.
4-52 OWNER'S HANDBOOK
2.
Connections to Hard Disk Power
Distribution Panel
1
Advertisement
Table of Contents
