Table of Contents
Advertisement
4.
Fasten the drive into the tray by means of the four screws on the
underside of the tray.
2
Figure 3-14 Hard Disk Drive Tray Securing Screws
1.
Securing Screws
5.
Insert the tray carefully back into the drive module and push it in
until it reaches the point where the hard disk release handle will
engage. You must not knock or jolt the hard disk drive.
6.
Turn the hard disk release handle clockwise almost one complete
turn until the tray metalwork is flush with the drive module. During
this procedure the hard disk plugs into the SCSI connector on the
drive module backplane.
Note
Since the hard disk drives for your Apricot are exclusively SCSI drives, it is
important to note that the SCSI connector on the inside of the drive module
backplane contains the device address. This means that, for a given connector, any
disk drive that is fitted to that connector will have the same SCSI address.
U p g r a d i n g Y o u r S y s t e m
1
2.
Disk Drive Tray
OWNER'S HANDBOOK 3-15
Advertisement
Table of Contents
