Table of Contents
Advertisement
To run the SCU:
Locally, press F2 to run the Flash Disk Utility during the hardware boot
sequence but before the operating system loads; remotely, run the Flash
Disk Utility via the SMA. You also can use the SMA to instruct the system
to load the SCU automatically (see the SMA User's Guide). The Flash Disk
Utility menu then appears on the screen.
1.
Select "Run Configuration Utility" from the Flash Disk Utility menu.
2.
At this point a further submenu appears. Choose one of the options
according to the following guidelines:
−
Choose "Run SCU" as the preferred option.
−
Since the SCU is limited to 640K base memory, there may not
be enough memory to load it plus all the configuration (.CFG)
files associated with the motherboard and the expansion cards
installed in your system. Your system will inform you if there is
insufficent memory. If this should happen, which is unlikely,
choose one of the other options in the submenu as an
alternative. "Run SCU (Motherboard)" excludes the expansion
card configuration files, thereby freeing memory. "Run SCU
(EISA/PCI)" does the same, but this time excludes the
motherboard configuration file to free memory.
The following menu then appears:
System Configuration Utility (C) 1995 American Megatrends Inc.
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
O p e r a t i n g Y o u r S y s t e m
About System Configuration
Add and Remove Boards
Change Configuration Settings
Save Configuration
View Switch/Jumper Settings
Exit
OWNER'S HANDBOOK 2-13
Advertisement
Table of Contents
