Table of Contents
Advertisement
Expanding the system
Configuration
Each SCSI drive is assigned an identity on the SCSI bus, these
are known as SCSI IDs. All authorized SCSI tape drives are
supplied configured with SCSI ID 2, the SCSI CD-ROM drive
is configured with ID 5.
All authorized SCSI drives are supplied with termination
resistors fitted.
3.5" hard disk drive
The system unit supports one 1.6" high or two 1" high, 3.5"
hard disk drives.
Preparation
To install a hard disk drive you must first remove the 3.5" drive
bay:
5/22 XEN OWNER'S HANDBOOK
1.
Power the system down.
2.
If there is a diskette in the 3.5" floppy drive, remove
it.
3.
Take suitable anti-static precautions and remove the
system unit cover.
If you are unfamiliar with the recommended anti-static
precautions and/or the process of removing the
system unit cover refer to the appendices at the rear
of this manual.
In order to remove the 3.5" drive bay you must first
remove the 5.25" drive bay.
4.
If there is a drive fitted in the 5.25" bay disconnect
the power and signal cables from the rear of the drive.
5.
Remove the two screws that secure the 5.25" drive
bay and slide the bay backwards.
6.
Lift the 5.25" bay out of the system unit and put it
down on a safe flat surface.
Advertisement
Table of Contents
